Why does my monitor keep going in power save mode?
#Mac screen saver mose install
Take the motherboard battery to an electronics store and get a replacement, then install this new battery in your computer.You could now be able to use your computer normally but you will lose the date and time settings when you disconnect the computer power cord since there is no motherboard battery present to store them.
![mac screen saver mose mac screen saver mose](https://media.idownloadblog.com/wp-content/uploads/2019/08/Change-Mac-Wallpaper-Screen-Saver-MacBook-Air.jpg)
Set the date and time of your PC using the "Date and Time" control panel.Restart your computer: it should power up normally (you might have some warning messages during the start-up sequence, but ignore them).Remove this battery from your computer.Open the case of your computer, visually locate the motherboard (the main circuit board) of your computer, visually scan for a button-cell battery (it looks like a watch battery but a little bit larger).The solution is to replace the button-cell battery on the motherboard of your computer:
![mac screen saver mose mac screen saver mose](https://br.atsit.in/fr/wp-content/uploads/2021/05/mac-wont-go-to-sleep-mode-how-to-fix-it-tested-solutions.jpg)
When your PC detects this battery is empty, it will go into a low-power mode). (The motherboard battery is used to store different settings when the PC power is off, such as date and time. Usually, this happens on a computer which is a few years old since its batteries will have run out after such a long time. In the case of laptops this could also be down to an empty battery. When you can't get a computer out of power save mode by any usual means, typically the cause is that the button-cell-type battery of your computer, located on the motherboard, is empty. Power saving mode has been designed in computers to save energy when there is no activity for a prolonged period or if the power source is not supplying power. Why my computer is going into power save mode? The only solution for this is to replace the battery with a new one and then restart the computer. If users face a scenario where their laptop computers cannot exit from the power saving mode, then it is problem with the battery located on the motherboard.